When operating my SteadyWeb 12P in
Manual mode I can dial in a tension of 145 pounds. When switching to Auto
mode and turning the tension knob fully clockwise I can only get up to
100 pounds. What's wrong?
This problem is usually the result of the automatic tension setting
being limited by an internal setting, and thus
not allowed to output it’s full signal. One likely cause is the tension
trim potentiometer being set at less than 100%. On the SteadyWeb
Control Board check that the Tension Trim Pot (RT105) is turned fully clockwise.
If so, check the + LIMIT pot (RT106). It should be turned fully clockwise
as well.
As an additional check, connect a volt meter between points 13(+) and
15(-) on terminal block TB203 of the SteadyWeb Power Board. At full output
both Auto and Manual modes should be at 10 VDC.
Back to Frequently Asked
Questions |
